PROMATION’s EWT station may be used for inspection of PCBs or rework. Equipped with an in-line conveyor, in AUDIT mode the station stops the PCB in the middle of the work station and waits for the operator to perform their function. Upon completion, the operator depresses a RELEASE that enables SMEMA and transfers the PCB to the end of the station. If the next process is available, the PCB will transfer out and another PCB will enter the station.

In PASS mode, the station assumes that no operator is present and the station acts as a transfer conveyor, passing PCBs between processes.EWT-700  Model w/Accessories

• Embedded logic controller 
• AC drive motor(s) with fixed belt speed
• Audit & By-Pass modes (selector switch)
• Retractable handle for width adjusting
• ESD grounding plug in port
• Audible alarm & Overhead Lighting
• Dual E-Stops and single Reset
• Easy Roll wheels w/leveling feet +/- 30 mm

Technical Specifications:

• 3 mm edge contact
• 1000 mm, 1200 mm, 1500 mm or other lengths
• Minimum PCB thickness 1 mm (0.045”)
• Maximum PCB weight 1.8kg (5 lbs)
• Voltage (USA = 110v) or (220 v optional)
• Power consumption: 74 watts 1A
• Top side clearance 30 mm (1.1”)
• Bottom side clearance 30 mm (1.1”)
• Look up product sensing (adjustable focal detection)
• Rail to floor height (950 mm) 37.4” or (900 mm) 35.4”

Available Options:                                        

• semi circle work surface
• variable speed dial
• adjustable rear parts tray
• automatic width adjustment
• multiple drives
• rear support table